www.nightvisionforumuk.com

Hello everyone, asking for a favour.

I need a t20 pill modified on a lathe, it needs the recess where the driver sits into deeper so that the double stack PCB driver will fit.

Ill include a stamped envelope so that it can be popped into the postbox at no cost.

Here's the pic


Cheers
Paul

It's probably be quicker and cheaper to buy a blank off Ian and ask him to skim it out a tad TBH.

That way if there are any mishaps he would be able to replace it.

or just take a dremmel/die grinder/drill to it

i can proberbly do that for you if you cant find any body nearer - just let me know -pm

I'd offer to help Paul but I have had three packages go awol in the last three weeks and now simply don't trust anything except RMSD.

if you have a even small drill press, with a rotatable table?

you could just chuck up a small "milling bit" that cuts a flat hole going DOWN IN, then simply rotate the table very slowly...

or, just the right size bit that drills a flat bottomed hole would do it... actually, since you are only moving the shoulder down, your only worried about the sides of the bit...

paul,

check you in box mate