Torch mount for the silencer

[bager]

I have made a torch mount for my silencer on a 3D printer. It works perfectly. The reason to move the IR torch is to reduce glare and improve the image in the scope. I taylor make every mount so that it fits YOUR silencer. It will function at extreeme temperatures also, as I have tried it at -16 degrees and it still works. I have tested it whit a Laserluchs and a Armasight XLR torch to perfect results. I have shot it several times with a 308wincester, and the mount does not move. Id did not move the point of impact on my rifle, but you will need to make a test shot as stuff mounted to the silencer might potentially need to be sighted in again.
I need to know the precise diameter in millimeters with an accuracy of 0,1mm to make the mount click on your scope and have a snug fit.
The groove in the weaver mount will be in the middel unless you specify othervise.

Price 27£ including shipping
You pay by paypal: jens@bager.info

Delivery is 2 weeks as I make then when they are ordered and shipping from Denmark takes some time

[bager]

Here is a picture og two different grove locations
https://www.dropbox.com/s/c4qdmog5jlhna ... e.JPG?dl=0

Here is a picture of the torch mount
https://www.dropbox.com/s/von25d0mrw6j9 ... t.JPG?dl=0