www.nightvisionforumuk.com

Would this be OK for a cheap multimeter http://www.ebay.co.uk/itm/271084296621? ... 1423.l2649, I know it's a copy or can somebody recommend one. I have a cheapy from Aldi's at the moment which is dying. Rob

Looks like a good 'un.

I use one of these, which does it for my needs:

http://www.machinemart.co.uk/shop/produ ... multimeter

George

PESCA wrote:Looks like a good 'un.

I use one of these, which does it for my needs:

http://www.machinemart.co.uk/shop/produ ... multimeter

George

Thanks George that's the same one I have at the moment the diode part is faulty.

I use one of these -
http://uk.rs-online.com/web/p/digital-m ... s/0412052/


I don't like the cheaper yellow ones because I like the buzzer on the continuity tester, I don't know what else is better because reading voltages, reading current and continuity is the end of my multimeter knowledge.

paulham wrote:I use one of these -
http://uk.rs-online.com/web/p/digital-m ... s/0412052/


I don't like the cheaper yellow ones because I like the buzzer on the continuity tester, I don't know what else is better because reading voltages, reading current and continuity is the end of my multimeter knowledge.

That looks good Paul but a bit over what I want to spend it's only for checking the oslon's once Iv'e soldered them. My knowledge on how to use of them is limited. Rob

paulham wrote:I use one of these -
http://uk.rs-online.com/web/p/digital-m ... s/0412052/


I don't like the cheaper yellow ones because I like the buzzer on the continuity tester, I don't know what else is better because reading voltages, reading current and continuity is the end of my multimeter knowledge.

Your doing better than me. I just knows a man who knows. I am dreading the wiring of my pan and tilt.

roughcoat wrote:Would this be OK for a cheap multimeter http://www.ebay.co.uk/itm/271084296621? ... 1423.l2649, I know it's a copy or can somebody recommend one. I have a cheapy from Aldi's at the moment which is dying. Rob

looks good from here, frequency and duty cycle too.

Thanks for the reply's think I'll go with the evil bay one. Rob