www.nightvisionforumuk.com

Hi All, Thanks for the comments and advise, all appreciated. I have looked many times at putting a Picatinney rail on the Blaser R8, but the cost of the rail, mounts etc. put me off, along with the need to recall different points of impact between all three rifle and the fact that regardless of what...

Morning Bruce, Thank you. I will focus on front tube add ons, probably resulting in me posting on gear to see what is best. When I spoke to Scott country they steered me towards the FLIR CO -X. However, I can find little in the way of a review for theses. I also need to understand the tube situation...

Sorry Bruce, I should add, it will take a lot for me to give up on the S&B’s . I’d rather find something that works with them. I’ve looked at rear tube add on’s but the Blaser is in a sporting configuration and chambered in .308. I’d not say it’s a kicker, but with most units I fear I would end up w...

Hi Bruce, Thanks for the input, always appreciated. The issue I had with the Ward Unit was not that it didn’t work, I couldn’t even get it on the scope to try. The S&B has a diameter of 50.00mm or near enough and the Ward in the region of 48.00mm. If I could have got it to fit, I’d not have sold it....

As titled, Hello to all. As you will have guessed I am new to the forum. I have limited knowledge regards night vision and thermal, just about enough to be dangerous some would say. Anyway, I’m probably out a couple, if not three times a week with a rifle of sorts and to date I only have person expe...